# Pipe Fence Installation in Hammond, LA

> Pipe fence installation around Hammond, LA: welded steel pipe rail, pipe and cable, and pipe with wire for entrances, pens and frontage, set for wet ground.

URL: https://palisadeshammondfence.com/pipe-fence-installation/

Service

Welded steel pipe rail, pipe and cable, and pipe with wire infill for ranch entrances, pens, arenas and road frontage, painted and capped against rust.

Get an Estimate

[(985) 866-3827](tel:+19858663827)

Last Updated: November 1, 2026

Every joint is welded, so the fence acts as one frame. Caps keep rain out of the posts, where it would rust them from the inside.

Pipe fence lasts as long as its paint and its post bottoms do.

Mon to Fri 8 to 6 · Sat and Sun 9 to 2

Pipe fence is the heavy-duty end of rural fencing: steel pipe posts with welded pipe rails, or pipe with cable or wire between. [Palisades Hammond Fence](https://palisadeshammondfence.com/) installs pipe fencing around Hammond and the rural towns nearby, for ranch entrances, road frontage, horse and cattle pens, arenas and alleys. Installation is carried out by licensed and insured fence contractors. A welded pipe fence acts as a single rigid frame, which is why it holds up where animals push hardest and where an entrance needs to look solid.

The trade-off is rust. In a climate with about 64 inches of rain a year and long humid summers, a steel fence lasts only as long as the coating on it and the steel at its post bottoms. Planning for that from the start is what separates a pipe fence that stands for decades from one that rusts out at the ground. For lighter pasture fencing, see [farm fence installation](https://palisadeshammondfence.com/farm-fence-installation/).

## Where pipe fence earns its cost

Pipe fence costs more per foot than wire or board, so it goes where its strength or look matters most:

- **Entrances and frontage.** A pipe rail fence along a road or around a gated entrance reads as permanent and needs little upkeep beyond paint.
- **Pens, alleys and working areas.** Cattle crowd and push in pens, and horses lean and rub. A welded frame shrugs that off where a board would crack.
- **Arenas and round pens.** Smooth, continuous rails with no exposed fasteners.
- **High-traffic corners of a pasture.** Near a barn, a water trough or a feeding area, where animals gather.

One practical mix is pipe at the entrance and pens, with field fence or board for the long perimeter. The [horse fence page](https://palisadeshammondfence.com/horse-fence-installation/) covers the horse side of that mix.

## Choosing a style

**Pipe rail** uses pipe posts with two to five horizontal pipe rails welded between them. It is the most rigid style and the one used at entrances and around arenas.

**Pipe and cable** keeps the pipe posts and top rail but runs tensioned steel cables below it. The cables give a little on impact, and fewer posts are needed for a long run. Like any tensioned fence, it depends on braced end and corner posts; if those move, the cables slacken.

**Pipe with infill** uses the pipe as a frame and fills it with welded wire, no-climb mesh or livestock panels. This holds small stock and dogs, and suits horse pens when the mesh openings are small enough that a hoof can’t go through.

### Pipe size, wall and source

Posts, top rails and lower rails are each sized for their loads; gate posts and corners use the heaviest pipe. Wall thickness matters as much as diameter, because a thin wall rusts through sooner. Used pipe, including oilfield pipe, is sold for fencing, and its wall thickness, internal corrosion and straightness vary from piece to piece. Sound used pipe makes a strong fence; each length is checked before it goes in.

## Posts in wet ground

A pipe post is a steel tube standing in soil that, around Hammond, stays wet much of the year. USDA soil data for Hammond maps mostly poorly drained silt loams with a seasonal water table between about 5 and 27 inches below the surface. Steel at the ground line rusts fastest, where it is wet and exposed to air, and moisture held against the post by soil or a cracked footing speeds that up.

Posts are set in concrete footings sized for the rail weight, the gates and the soil, and the concrete is finished above grade and crowned so water runs off. Open post tops are capped with welded caps so they don’t fill with rain and rust from the inside. Where a post is cut to height, the cut is sealed. The [wet clay post guide](https://palisadeshammondfence.com/guide/fence-posts-in-wet-clay-soil/) covers footings in this soil.

Before any hole is dug, Louisiana’s damage prevention law requires an 811 notice at least 48 and no more than 120 hours ahead, weekends and holidays excluded. Road frontages can carry buried utility lines, which is one more reason the locate comes first.

## Welding and paint

Pipe fence is assembled by welding in the field: rails to posts, caps on posts, hinges to gate posts. Each weld burns off any coating around it, so welds are cleaned and primed before painting. Paint is a system: cleaning off mill scale and rust, a rust-inhibiting primer, then a topcoat. Painting is priced as its own line, because it adds real time and materials.

Rust starts first at the welds, at chips from mowers and equipment, and at the post bottoms. In this climate, touching those up every few years keeps a pipe fence sound.

## Pipe gates

Pipe fences are usually paired with pipe or tubular steel gates hung on weld-on hinges. A pipe gate is heavy, so the hinge post is the heaviest post in the line and gets the largest footing. Gates for a tractor, trailer or cattle truck are sized to the widest vehicle, and a chain or latch is set where an animal can’t work it open. For a gated entrance or a wider swing, see [driveway gate installation](https://palisadeshammondfence.com/driveway-gate-installation/) and [gate installation](https://palisadeshammondfence.com/gate-installation/).

## Rules and boundaries

Under Louisiana Civil Code article 685, a fence on a boundary is presumed common to both neighbors, and article 686 presumes a ditch between two properties common as well, so a frontage or side line along a ditch involves the neighbor. The [Louisiana fence law guide](https://palisadeshammondfence.com/guide/louisiana-fence-laws/) explains those rules.

Inside the City of Hammond, a fence permit is required ($10 residential, $50 commercial, doubled if work starts first). A metal fence may stand in front of the house up to 4 ft, but not as chain link or wire, so wire-infill pipe stays behind the front building line. Most pipe fencing goes in outside city limits, where the parish or town rule is confirmed per address; the [fence permit guide](https://palisadeshammondfence.com/guide/fence-permits/) explains both.

## What a pipe fence costs

There is no published Hammond-area price range for pipe fence. It is priced from the pipe diameter and wall thickness, the number of rails or cables, the welding and fabrication, the post setting depth and footings, the length of the run, the gates and the paint. Used and new pipe differ in material cost. The [farm fence cost guide](https://palisadeshammondfence.com/guide/farm-fence-cost/) walks through those drivers alongside wire and board fencing.

## What's included

- Walking the line for length, grade, low spots, ditch crossings and gate locations
- Choosing the style: pipe rail, pipe and cable, or pipe posts with wire or panel infill
- Pipe size and wall thickness for posts, top rail and lower rails
- Posts set in concrete at a depth and diameter for the soil and the loads
- Field welding of rails, caps and gate hinges
- Capping open post tops so they don't fill with water
- Cleaning, priming and painting, priced as its own line
- Pipe gates hung on heavy posts with weld-on hinges and a chain or latch
- The Louisiana 811 locate before any post hole is dug

## Pipe fence styles

|  | Pipe rail | Pipe and cable | Pipe with wire or panel infill |
| --- | --- | --- | --- |
| What it is | Pipe posts with two to five welded pipe rails | Pipe posts and top rail with tensioned steel cables between | Pipe frame with welded wire, no-climb mesh or livestock panels |
| Best for | Entrances, frontage, arenas, pens | Long cattle runs and pasture divisions | Horse pens, small stock, dog-proof areas |
| How it holds | Rigid welded frame | Cable tension on braced ends | Frame stiffness plus infill |
| Watch for | Rust at welds and post bottoms | Cable slack if end posts move | Openings sized for the animals |
| Typical Hammond-area price | No published range; pipe size, welding and paint set it | Same | Same, plus the infill |

## Related resources

Cost Guide

How Much Does Farm Fence Cost per Foot Near Hammond, LA?

Why pasture fence has no single per-foot price here, how length, corners, ground and gates set the scope, and how to describe a job so quotes can be compared.

Decision Guide

Which Horse Fence Type Suits Your Pasture?

What a horse fence has to do that a yard fence doesn't, how board, polymer rail and woven mesh each meet it, and why a decorative rail fence isn't horse containment.

Learn

How Should Fence Posts Be Set in Wet Clay Soil?

What the ground under a Hammond-area fence is actually like, why posts rotate in it, how footing depth and type are chosen, and how a post hole that fills with water is handled.

Learn

Do You Need a Permit to Build a Fence in Louisiana?

Louisiana leaves fence permits to each city and parish. Here is what Hammond and Covington require, what is known about Mandeville, and how heights, setbacks and corner lots shape the application.

Learn

What Are Louisiana's Fence Laws for Property Lines and Neighbors?

What the Louisiana Civil Code says about enclosing land, fences on a shared line, boundary markers and long possession, and where city codes take over for height and front yards.

## From the first call to the last gate

1. First call You describe the fence, the yard and the timing, and set a visit.
2. Site visit The line is walked and measured, gates and slopes noted, and the soil and drainage checked.
3. Permit and 811 The permit drawing goes to the city or parish, and utilities are located before any digging.
4. Build Posts are set and allowed to cure, then rails, panels or fabric and gates go up.
5. Walkthrough Gates are adjusted, the site is cleaned, and you check the finished line.

## What this work looks like

A welded steel pipe fence painted white along the road frontage of a rural property, with a matching pipe entrance gate

A small round steel pipe corral pen in a flat pasture beside a barn

## Questions about pipe fences

### Is used pipe good enough for a pipe fence?

It can be, if its wall thickness and condition are checked. Used pipe, including oilfield pipe, varies in wall thickness, internal corrosion and straightness from piece to piece. Sound used pipe makes a strong fence; pitted or thin-walled pieces rust through sooner, especially at the ground line. Whatever the source, it gets cleaned, primed and painted.

### Why do pipe fence posts get capped?

An open post top collects rain. Water sits inside the post, rusts it from the inside where you can't see it, and in time rots through at the ground line. A welded cap, or a dome cap on a cut post, keeps rain out. Rails welded into the posts also need their ends closed.

### How often does a pipe fence need painting?

It depends on the paint system, the sun and the humidity, but in this climate expect to touch up chips and rust spots every few years and repaint fully less often. The post bottoms and welds rust first. Catching rust early, while it is on the surface, is far cheaper than replacing a post that rusted through.

### Can a pipe fence go across a front yard in Hammond?

Inside city limits a metal fence can stand in front of the house up to 4 ft high, and it cannot be chain link or wire. A pipe rail fence of that height fits; one with wire infill does not. Behind the front of the house, fences can reach 8 ft. A fence permit is required either way.

### Do pipe fence posts need concrete?

In most cases, yes. A pipe post driven or set in loose soil can lean under the weight of the rails and gates, especially in wet ground. Concrete footings anchor the welded frame. Corner, end and gate posts get the largest footings, and the concrete is finished above grade so water drains away from the steel.

## Related services

### Farm fences →

Woven field fence, barbed wire and high-tensile wire for pasture, livestock and acreage, on braced corners and posts set for wet ground.

### Horse fences →

Board, rail and no-climb mesh fencing for horse pastures, paddocks and turnout pens, with braced corners, smooth faces and gates planned for horses and tractors.

### Driveway gates →

Manual single-leaf and double-leaf driveway gates in wood, steel, aluminum and chain link, sized for the vehicles that use them and hung on posts built for the weight.